Hyundai Tucson: IMT System Actuator
Components and Components Location
- IMT system actuator
Connector and Terminal Information
Circuit Diagram
- IMT System Actuator- Replacement
- IMT System Actuator- Inspection
- IMT System Actuator- Removal
- IMT System Actuator- Installation
READ NEXT:
IMT System Actuator- Replacement
iMT system actuator fluid - when fluid suction tool is available
Remove the air cleaner assembly and the air duct.
(Refer to Engine Mechanical System - "Air Cleaner")
Remove the reservoir cap (A) and drain the imt system actuator
IMT System Actuator- Inspection
IMT system clutch tube and line
Remove the air cleaner assembly and the air duct.
(Refer to Engine Mechanical System - "Air Cleaner")
Check conditions (disassembled, damaged) of the clutch tube (A) and
check leakages of the co
IMT System Actuator- Removal
In case of transaxle separated from the vehicle
Remove the Intelligent Manual Transaxle (IMT).
(Refer to Intelligent Manual Transaxle (IMT) System (M6CF3-le) - "Intelligent
Manual Transaxle
(IMT)")
Pull the clip (A).
SEE MORE:
The Procedure of Manual Tolerance Compensation
Advanced preparations will be made according to the following.
Confirm that the car hood, trunk and door are closed.
The door is closed after getting in on the passenger side.
Unfold the side mirror if it is folded in.
Put the gear int
Measuring the resistance of the pressure sensor
Turn ignition switch OFF.
Disconnect the pressure sensor connector.
Measure resistance between sensor terminal and terminal.
Check the measured resistance. (Refer to table)
Table 1
Removal
Remove the coupling assembly.
(Refer to
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
